During the initial era of air travel how do the pilots/Navigation officers would communicate with ground stations?
Do they use radio communication? Or Telegraph was used?
Asked
Active
Viewed 8,836 times
20
-
28Given that telegraph requires wires, I doubt that they used that. – Simon Jun 05 '14 at 07:44
-
6given that radio was available before planes I'd say radio – ratchet freak Jun 05 '14 at 07:48
-
3@ratchet freak: I'm pretty sure that the earliest planes did not have radio, including at least some WW1 fighters. – RedGrittyBrick Jun 05 '14 at 07:59
-
2then they could have used light signals (it's still the radio backup today) – ratchet freak Jun 05 '14 at 08:21
-
4There was such a thing as wireless telegraph, but of course it's a form of radio that only carried Morse code instead of voice. – Fred Larson Jun 05 '14 at 16:50
-
There's lots of information in this PDF (APPENDIX 1. Signals.) on visual signals such as light, pyrotechnics, and wing waggling http://www.icao.int/Meetings/anconf12/Document%20Archive/an02_cons%5B1%5D.pdf – Matthew Lock Jun 06 '14 at 05:29
-
4Well, obviously they used pigeons. – Vitaly Mijiritsky Jun 06 '14 at 17:49
5 Answers
28
Radio was not widely used until the 1930s, before that, mostly light signals were used. Early ground support aircraft in WW I could drop little notes which were pencilled by the observer, stuffed in a small capsule to which a streamer was fitted, and that was dropped as closely as possible to the troops which should get that message. This method was still used in WW II, when most aircraft had radio, because only specially equipped ground troops had compatible receivers.
The first regular flights by night were 1921 for the air mail connection between Omaha and Chicago, and electric flood lights were positioned along the flight path. When Lufthansa opened the first night connection between the Reich and East Prussia in 1926, they posted burning oil drums along the way to mark where the pilot had to fly. Communication the other way (air to ground) was not possible on those flights.
The first air-to-ground radio communication used morse signals, and this is the origin for these strange three-letter names for things like local air pressure at the ground (QFE) or pressure corrected to sea level conditions (QNH). There was a whole lot more of those, including some to order coffee before landing, but they are no longer necessary. Read all about it here.
Peter Kämpf
- 231,832
- 17
- 588
- 929
-
15
-
-
@DJClayworth I'm sure I recall reading about some form of air to air visual communication protocol which allowed spotter to relay information from an aircraft without radio. But I've no idea of the source. Some form of Morse probably. – Chris H Jun 06 '14 at 09:35
-
Flying boats in airline service as late as 1950 or so, as well as in military service during WWII, were equipped with signal lights like those commonly seen on ships in war movies, used through the navigation dome above the cockpit (where the navigator took sun or star sightings to fix location). How effective they were from aircraft to aircraft is questionable, and they'd only have been visible from another aircraft at or above the same altitude in any case. – Zeiss Ikon Oct 20 '21 at 17:54
-
@ZeissIkon That was particularly popular on British airplanes and copied from naval traditions. Other nations used more modern means. – Peter Kämpf Oct 20 '21 at 18:20
14
While radio was available (meaning it existed) it did not exist in a form usable by early aircraft.
If you are talking early-early travel, not commercial travel, communication was not necessary. Navigate to the destination, circle the (farmer's) field to check for livestock, then land. Communication with other aircraft was not necessary as there usually were no other aircraft.
As things progressed, morse code became practical. This was when cockpit crews required both hands to count.
paul
- 14,775
- 3
- 43
- 55
6
Up until World War One, there was no radio communication between air and ground, or between planes. Communication from ground to air was done by means of light signals.
From 1915 onwards aircraft were used as artillery spotters which involved Morse code wireless signals one-way, (from the aircraft to the ground). There was no communication from ground to air, and the air-to-ground communication was limited to simple codes. The only form of air-to-air communications was signals such as 'wing-waggling'.
Air-to-ground and air-to-air spoken radio communication became common between the wars, and was widespread in major air forces at the start of WW2. It was used for air-to-air communication and short range air to ground, for example controlling interceptor fighters within the home country. Morse code remained in use for longer ranges, such as a bomber over a foreign country communicating with home.
DJClayworth
- 3,728
- 17
- 32
3
In World War 1 there were aircraft spark gap transmitters and the pilot could send messages in Morse code to receivers on the ground but he could not receive wireless (now called radio) signals. There was limited communication from ground to aircraft using the following three methods; Ground Strips. Lamp Signals. Poppet Panels. The pilot had to fly and watch for signals at the same time. Ground strips were white sheets 3 metres by 300 mm (10 feet by 1 foot) or larger. They were laid out as patterns or letters with a letter for such messages as 'Your (wireless) signal is weak' or, 'Repeat last (wireless) message' or 'I am not receiving your signal'. Lamp signals, used later in WW1, used 'Lucas' signalling lamps. The operator aimed the light beam at the pilot when he thought it would be visible to him and send the message in Morse Code. The Poppet Panel was a canvas shutter arrangement fixed to the ground and was worked by pulling a cord which made a white patch visible from the air. When the cord was released the panel showed a black patch. By pulling and releasing the cord the operator could send Morse Code messages to the pilot who had to fly with one hand, look over the side and write down the letters with his other hand. It was a difficult task.
Jim Gordon
- 31
- 2
-
-
2@SMSvonderTann The source is three books written by WWI wireless operator, Bert Billings. He served in Gallipoli and Egypt then transferred to the Royal Flying Corps and trained pilots. The only copies of his books are in the Australian Army Signals Museum in Victoria and the War Memorial in Canberra. I have just submitted a 14,200 word article based on his books for publication. I am the former manager of the Signals Museum so have access to the books. Google the various communication systems that I have briefly described in my answer. You should find some additional information. – Jim Gordon Feb 12 '16 at 04:36
-
2You might want to put that at the end of you post saying: "Source: " And the title of those books. – SMS von der Tann Feb 12 '16 at 13:04
-
@SMSvonderTann. Thanks for your advice but I don't see other postings referenced with sources. If you are interested in the subject do a thorough search on Ground Strips, Lamp Signals, Poppet Panels, Lucas' signalling lamps, with additional terms such as WW1, aircraft, artillery spotting, Hubert (Bert) Billings etc and you should find other sources of the same information. The only two copies of the three books by Bert Billings, apart from copies that members of his family have, are in the Australian Army Signals Museum in Victoria and the War Memorial in Canberra, Australia. They are My Story – Jim Gordon Apr 06 '16 at 12:40
2
Military aircraft frequently used radiotelegraphy (Morse code) well into WWII, if not 'til the end. The binary nature of it (on/off constant amplitude signal*) gave greater effective range and more resistance to degradation by static than radiotelephony (voice). Most aircraft had voice radios for communication with nearby friendly aircraft and bases, but relied on Morse code at long ranges.
* shades of digital transmissions today!
Phil Perry
- 453
- 2
- 8