0

I was making low-poly Audi A6 C6 avant. So i made almost everything but I have a problem. When I try to make the last wall of the roof, a problem arises. One of the edges spoils the whole look. I use the Subdivision Surface but even when it turns it off, the error still shows up. Please helpenter image description here

enter image description here

It's not even helping when using "Shade Flat". And yes, I enabled AutoSmooth to 30*

Martin kovski
  • 1
  • Could you post an image of your object in edit mode without the SS modifier so we can see the topology? It's likely just a duped or unmerged edge or possibly a slight upward "kink" in the mesh surface. Either way, its hard to tell without seeing the edge lines. – Christopher Bennett Jan 27 '21 at 16:23
  • https://pasteboard.co/JLBrYiH.png here you are – Martin kovski Jan 27 '21 at 16:43
  • Still nothing. When I'm trying to fill the empty face it creates a weird edge, that is sharp... Sorry for my bad english. – Martin kovski Jan 27 '21 at 17:47
  • Yeah, not sure then. have you tried removing all dupes (Select all in edit mode, then mesh > Clean up > Merge by distance) and making sure the normals are all facing the right way (mesh > normals > recalculate outside)? – Christopher Bennett Jan 27 '21 at 18:11
  • Yeah, thank you :DDDDD Some faces were inverted, so it was looking weird. Once again, thank you :) – Martin kovski Jan 27 '21 at 18:47

0 Answers0