How can I select edge loops in a mesh using geometry nodes?

Asked Mar 04 '24 at 20:19

Active Mar 04 '24 at 20:19

Viewed 21 times

In my scenario, I have a few stacks of edge loops bridged together and am seeking a way to select a specified loop using geometry nodes to perform transformations on.

A mesh I am working on which contains 6 horizontal loops with 600 vertices per loop. I want to be able to feed each selected loop through transformation nodes I have implemented (gif animation)

asked Mar 04 '24 at 20:19

SebaYoung

You could select your loops based on z-position. Did you try it ? – Lutzi Mar 04 '24 at 20:23
May I suggest to read this post: How to Select every other Edge in Geometry Nodes ? – StefLAncien Mar 04 '24 at 20:43
Does this answer your question? How to Select every other Edge in Geometry Nodes – Leander Mar 05 '24 at 07:04
It's a bit unclear at what stage you want to make the selection.. would something along these lines do it for you? – Robin Betts Mar 05 '24 at 08:42
Thank you for the suggestions, I have only tried selecting by Z-position so far but get strange results when plugging it into the vertex transformation. However, I will investigate and try again and also give the other solutions a shot this week – SebaYoung Mar 05 '24 at 23:22

How can I select edge loops in a mesh using geometry nodes?

0 Answers0