Was going through a tutorial, and I forgot to enable I2C interface and load the I2C kernal module, as well as a few other things. I just want to get it back to the point as if I didn't configure anything, and I had just pulled it out of the box.
Asked
Active
Viewed 419 times
3 Answers
7
Simply rewrite the SD card with a fresh copy of NOOBS or Raspbian and it will be back to brand new!
adengle
- 716
- 5
- 6
-
Shouldn't the firmware be downgraded as well (to get the "out-of-the-box" equivalent)? – WoJ Jan 12 '16 at 09:52
-
The "firmware" is stored as an file on the SD card. It is loaded before the OS loads. – adengle Jan 12 '16 at 13:25
-
Ah, ok - thanks. I thought it was flashed somewhere. – WoJ Jan 12 '16 at 13:36
2
No need to flash everything again. Just do sudo raspi-config and choose "Advanced settings" there you can enable I2C.
BallerNacken
- 351
- 1
- 4
- 13
1
If you're not afraid of losing any saved data, programs etc. then why not just reformat the SD card and load a fresh copy of your preferred OS?
LBaelish
- 195
- 2
- 8